Kodak RP 30 manual Calibration of New Paper, Emulsion Changes Master Paper

Tests

Calibration of New Paper, Emulsion Changes, or Correction of a Paper Channel (Not Master Paper)

1.Print an MBL.

This provides for a calibrated condition of the system.

2.Print the PBL right after the MBL:

•With laser point for new papers other than the master paper or

•Without laser point if there was an emulsion change only

Calibration of New Paper, Emulsion Changes (Master Paper)

1.Print the MBL on the previous (old) emulsion.

This provides for a calibrated condition of the machine.

2.Immediately print a PBL without laser point on the new master paper.

NOTE: If the old emulsion was used up before an MBL could be printed, the calibration of the new paper can only be started with a PBL calibration. However, in this case be sure that the equipment is calibrated. Otherwise, there may be a deviation between the master paper and all other papers. If this is the case, perform a complete new calibration.

Completion of the New Calibration

If there is too much deviation in the paper styles, a new calibration is recommended.

1.Print an MBL on master paper

2.Immediately print a PBL without laser point for all papers other than the master paper.

After manipulations on the laser module or after changing the chemicals, a new calibration is recommended:

1.Print a PBL with laser point on the master paper.

2.Print an MBL.

3.Immediately print a PBL with laser point for all papers other than the master paper.

KODAK PROFESSIONAL RP 30 Laser Printer 5-9