Operator’s Guide

Safety Precautions

Legal Notice

The RP 30 Laser Printer is designed for operation in conformance with all local safety regulations.

Follow all safety regulations, warnings, and instructions on machine labels. Failure to observe these regulations may result in personal injury or damage to the equipment and working area.

The manufacturer and service provider will not assume any responsibility for accidents and damage resulting from incorrect operation.

General Precautions

Never modify or rewire electrical circuits.

Do not circumvent or disable the integrated safety devices.

Do not modify preset values of safety components.

Replace fuses only with the same type of fuse (amp value, switch-off characteristics).

When Operating the Equipment

WARNING:

Do not operate the equipment without the covers and panels.

 

Persons who open or remove covers expose themselves to

 

dangerous voltages and other risks of injury.

Do not cover or block the vent openings in the housing. This may lead to overheating of components.

Do not allow objects or liquids to enter the equipment through the vent openings. This may cause fire or electrical shock.

Do not allow the power cable to be squeezed or crimped. Install the power cable so that it will not cause someone to step on or trip over it.

Avoid the excessive generation of dust. This may damage the components in the machine.

When Disposing of the Equipment

The RP30 contains a small amount of lead in circuit boards and mercury in the backlight of the LCD monitor. Disposal of these materials may be regulated due to environmental considerations. For disposal or recycling information, please contact your local authorities, or in the USA, visit the Electronics Industry Alliance website at www.eiae.org.

viii

KODAK PROFESSIONAL RP 30 Laser Printer

Page 11
Image 11
Kodak RP 30 manual Safety Precautions, Legal Notice, General Precautions, When Operating the Equipment