Correcting System Conditions

Error Handling

General

1.Remove errors if the cause is known.

2.Touch Clear if this button is shown.

3.If required, touch the Stop button on the screen, wait until the paper transport of the printer is empty, and touch Yes to initiate a reset. The screen remains gray during the reset procedure. The duration is approximately 3 minutes.

4.If the message Reset successful appears, the work can be continued. If not, other actions must be taken.

Unresolved Errors

1.Touch the i button to open the error list. All error messages shown in the status line are saved. The list shows the error messages along with the date and time of occurrence.

2.If an error in the paper processor has not been removed, mark the error message and touch Cancel selection.

3.Messages of the printer mainly refer to paper that must be removed. Remove the paper.

4.Deactivate Show all errors so that only active errors are displayed. Remove and delete all active errors from the list with Cancel selection.

5.If the system still does not perform a reset automatically, exit the error list and touch Stop to reset the system manually.

6.If the reset is unsuccessful, open one of the two front doors. This makes all relevant error messages visible again. The large error pop-up windows are displayed again.

7.If the loop – constantly unresolved errors – cannot be interrupted, press the ON button.

Gray Screen After Reset

If the screen remains gray for more than 3 minutes after a reset, push the ON button.

KODAK PROFESSIONAL RP 30 Laser Printer

7-5

Page 175
Image 175
Kodak RP 30 manual Error Handling, General, Unresolved Errors, Gray Screen After Reset