Konica Minolta BP-200, 250, 350 manual Specifying additional functions

Scan to SMB 5

5.3Specifying additional functions

You can add the following functions by pressing the [Fax/Scan] key on the control panel, then touching [Menu] on the screen that appears.

2 Note

If the optional fax kit has been installed, [Menu] changes to [Fax Menu]. 2

Note

The following functions and parameters have no effect, even if settings have been specified.

-“TSI” on the Setting 1 tab

-“Rotation TX” on the Setting 1 tab

-“Subject Selection” on the Network tab

-“Reply Address” on the Network tab

Item		Description
Setting 1	TX Report	Select under which conditions the transmission report is to be output.
*(Set 1)		Default: Outputs according to the specifications of the administrator.
		ON: Prints regardless of the transmission results.
		If TX Fails: Prints only when undeliverable.
		OFF: Does not print regardless of the transmission results.
	2in1	Select whether to send using the 2in1 function (printing two pages to
		fit on one page).
	2-Sided TX	Select whether to perform double-sided transmission. You can spec-
		ify the position of the binding margin and the document orientation.
Setting 2	Priority TX	Select whether a job is given priority over others.
*(Set 2)
	Timer TX	Select whether to set the send time. Specifies the send time when
	Setting	“ON” is selected.
	Stamp	Specify whether the document is stamped to indicate that it has been
		scanned. The document must be loaded into the ADF.
		2
		Note
		To use the Stamp function, optional stamp unit must be
		installed.
Network	File Name	Enter when a set file name is to be specified as the file name when
*(Net.)		saving the file. Up to 16 characters can be entered.
	E-Mail Noti-	Specify whether to have an e-mail message sent to a specified one-
	fication	touch destination to notify you when the transmission is complete.

* Changes to ( ) if the optional fax kit has been installed.

Scan to SMB Chapter 5

200/250/350 5-15