Konica Minolta C451 manual Troubleshooting, 10-3

Troubleshooting

10

10.2Unable to specify desired settings or unable to print as specified

Perform these troubleshooting procedures if you cannot specify the desired settings in the printer driver, or if the print results do not represent the set- tings that have been specified.

Note

Some of the printer driver functions cannot be combined with other func- tions.

Symptom	Probable cause	Action
A printer driver setting	Some functions cannot be com-	Do not try to select settings that
cannot be selected.	bined.	are not available.
The “Conflicts” mes-	An incorrect combination of func-	Check the settings and specify
sage with “Unable to	tions has been specified.	the functions correctly.
Select” or “Function
Canceled” appears.
Printing is not per-	Incorrect settings are specified.	Check each setting in the printer
formed as specified.		driver.
	A combination of functions, al-
	though possible in the printer driv-
	er, is not possible with this
	machine.
	The paper size, orientation, and	Enter the correct settings in the
	other settings specified in the ap-	application.
	plication have priority over those
	specified in the printer driver.
The watermark cannot	The watermark is not correctly	Check the watermark settings.
be printed.	set.
	The watermark density is set to a	Check the density settings.
	level that is too low.
	Watermarks cannot be printed in	No watermark can be printed in
	graphics applications.	this case.
The staple function	Stapling is not possible if “Paper	Check each setting in the printer
cannot be specified.	Type” is set to “Thick” or “Trans-	driver.
	parency”.
	The staple function requires op-	Install the required optional finish-
	tional finisher.	er and enable it using the printer
		driver.
Stapling cannot be	If are a large number of pages to	Change the number of pages to
performed.	be printed, stapling cannot be	be printed.
	performed.
	Stapling is not possible if the doc-	Check the document.
	ument contains pages of different
	sizes.

C451 10-3