Konica Minolta FAX2900/FAX3900 manual Connecting the Network Cable

2

Connecting to a Computer

2.2Connecting the Network Cable

Insert the connectors on the network cable into the network ports.

Note

This connection is available only with FAX3900.

Be sure to use a shielded Category 5 or 5E network cable. Use of an unshielded cable may result in radio frequency interference.

1Insert the connector on one end of the network cable into the network port as shown in the illustration.

2Insert the connector on the other end of the network cable into an available port on the network hub.

About the LEDs
LED1 (LINK):	This LED lights up when the network cable is
	connected correctly. If this LED is not lit, check
	the connection again, even if the copier appears
	to be connected correctly. If this LED is not lit
	when both ends are connected correctly, the
	network cable may be damaged.
LED2 (ACT):	This LED blinks when data is being transferred.

2-2