*The viewfinder LED lights red after a flash photograph is taken to indicate that the flash is charging. Wait until the viewfinder LED turns off before taking the next flash photograph.

Selftimer Button

This button enables the camera to release the shutter automatically and is used when the photographer wishes to be included in the photograph. Since it is necessary to keep the camera stable when the selftimer is used, the use of a tripod is recommended. In the initial setting, the shutter will release approximately 10 sec. after the shutter button is pressed.

1.Set the mode select dial to Photo ().

Note:

*When the power is already turned on with Playback () or set up (SET UP), set the mode select dial to Photo () to cancel these two

modes and open the lens cover automatically.

2.Press the power button.

The lens cover will open automsatically.

3.Press the selftimer button ( ). The self- timer mark () will ap- pear in the data display

panel and the selftimer mode will be activated.

4.Gently press the shutter button fully. The selftimer LED on the

front of the camera will start to blink. Approxi- mately 10 sec. later the shutter will release.

Notes:

*Press the selftimer button a second time to cancel the selftimer while it is operating.