Manuals / Kraftware Corporation / Kitchen Appliance / Garbage Disposal

Kraftware Corporation DS-16M2, DS-32M2 NOTE The ball studs support the bezel, Rear u-shapedflange

Models: DS-32M2 DS-16M2

1 22

Download 22 pages 39.92 Kb

Page 10

NOTE: The ball studs support the bezel.

Installing the DS-16M and DS-32M Rails

Latch

7.If you are installing the switch in a 39U cabinet, position the #10 washer and ball stud in the center hole, between the two M5 x 12 mm screws. Hand-tighten the ball stud.

NOTE: The ball studs support the bezel.

If you are installing the switch in a 40U cabinet, use an M5 x 12 mm screw to install the latch bracket in the center hole, over the keyplate spacer. See the figure below.

Keyplate

Spacer

Bracket

Screw

EMC2422

8.Align the holes in the rear, u-shaped flange of the rail with the holes in the rear inside channel.

Rear (u-shaped) flange

10

EMC Departmental Switches DS-16M2 and DS-32M2 Installation Guide

Image 10

Kraftware Corporation DS-16M2, DS-32M2 installation instructions NOTE The ball studs support the bezel, Rear u-shapedflange

Contents

EMC Departmental Switches DS-16M2and DS-32M2 Installation GuideDevice Placement Requirements Device Power, Cooling, and Weight InformationDevice Dimensions Power RequirementsSwitch Mounting Kit DS-16Mor DS-32M Component5/16-in.nut driver Tools Required for Installation# 1 Phillips head screwdriver 1/4-in.nut driver ComponentInstalling the DS-16Mand DS-32MRails Installing the DS-16Mand DS-32MRailsFront View Rear View DS-16MRails Installation 1.Assemble the rails Top up and to the rack front Installing the DS-16Mand DS-32MRailsFlange to the inside of the channel rack front DS-16M Square-Hole SwitchDS-16M Round-Hole Channel, Rack FrontNOTE The ball studs support the bezel Rear u-shapedflange10. Repeat steps 1 through 9 for the other rail DS-32MRails Installation 1.Assemble the rails Installing the DS-16Mand DS-32MRails Flange to the inside of the channelChannel, Rack Front DS-32M Round-HoleDS-32M Square-Hole Channel, Rack/Cabinet Front9. Repeat steps 1 through 8 for the other rail Installing the DS-16M2and DS-32M2Switches Mounting Bracket InstallationFan end of switch Installing the Switch in the Rack/CabinetAlign middle hole first C channel Installing the DS-16M2and DS-32M2SwitchesAlign hole in bracket with hole in the fixed rail Installing the DS-16M2and DS-32M2Switches Secure cords with retainer clip Installing the DS-16M2and DS-32M2SwitchesRun cables down trough Trademark Information Installing the DS-16M2and DS-32M2Switches