Kraftware Corporation DS-32M2, DS-16M2 Repeat steps 1 through 9 for the other rail

Installing the DS-16M and DS-32M Rails

9.Secure the rail to a round-hole rear channel with 2 M5 x 12 mm pan-head screws (see the table on page 3), or secure the rail to a square-hole rear channel with 2 square-hole washers and

M5 x 16 mm flat-head screws (see the table on page 3). Leave the screws finger-tight, and tighten them after the switch is installed. See the figures below.

DS-16M Round-Hole	DS-16M Square-Hole
Channel, Rack Rear	Channel, Rack Rear
(for example,	(for example, Third Party
CLARiiON Rack/Cabinet)	Rack/Cabinet)

10. Repeat steps 1 through 9 for the other rail.

EMC Departmental Switches DS-16M2 and DS-32M2 Installation Guide

11