Kraftware Corporation DS-32M2, DS-16M2 DS-32M Round-Hole, DS-32M Square-Hole, Channel, Rack Front

Installing the DS-16M and DS-32M Rails

DS-32M Round-Hole	DS-32M Square-Hole
Channel, Rack Front	Channel, Rack/Cabinet Front

If you are installing the switch in a 40U cabinet, use the appropriate screws to install the latch bracket (instead of the ball stud) to the outside edge of the channel as you secure the rail. To attach the bottom latch bracket screw, install an M5 clip nut over the aligning hole in the channel. See the following figure.

Step 1	Switch	Step 2
	Mounting Rail
		2U Bracket
		(Left)
Screw		Screw
		(2)
	Clip Nut

Switch Mounting Rail

Left Front Left Front

EMC2421

7.Align two holes in the rear, u-shaped flange of the rail with two holes in the rear inside channel.

EMC Departmental Switches DS-16M2 and DS-32M2 Installation Guide

15