Manuals / Kraftware Corporation / Kitchen Appliance / Garbage Disposal

Kraftware Corporation DS-16M2, DS-32M2 Repeat steps 1 through 8 for the other rail

Models: DS-32M2 DS-16M2

1 22

Download 22 pages 39.92 Kb

Page 16

9. Repeat steps 1 through 8 for the other rail.

Installing the DS-16M and DS-32M Rails

8.Secure the rail to a round-hole rear channel with two M5 x 12 mm screws (see the table on page 3), or secure the rail to a square-hole rear channel with two square-hole washers and M5 x 16 mm screws (see the table on page 3). Leave the screws finger-tight, and tighten them after the switch is installed. See the figure below.

DS-32M Round-Hole	DS-32M Square-Hole
Channel, Rear	Channel, Rear

9. Repeat steps 1 through 8 for the other rail.

16

EMC Departmental Switches DS-16M2 and DS-32M2 Installation Guide

Image 16

Kraftware Corporation DS-16M2, DS-32M2 installation instructions Repeat steps 1 through 8 for the other rail

Contents

EMC Departmental Switches DS-16M2and DS-32M2 Installation GuideDevice Power, Cooling, and Weight Information Device DimensionsDevice Placement Requirements Power RequirementsSwitch Mounting Kit DS-16Mor DS-32M ComponentTools Required for Installation # 1 Phillips head screwdriver 1/4-in.nut driver5/16-in.nut driver ComponentInstalling the DS-16Mand DS-32MRails Installing the DS-16Mand DS-32MRailsFront View Rear View DS-16MRails Installation 1.Assemble the rails Top up and to the rack front Installing the DS-16Mand DS-32MRailsFlange to the inside of the channel rack front Switch DS-16M Round-HoleDS-16M Square-Hole Channel, Rack FrontNOTE The ball studs support the bezel Rear u-shapedflange10. Repeat steps 1 through 9 for the other rail DS-32MRails Installation 1.Assemble the rails Installing the DS-16Mand DS-32MRails Flange to the inside of the channelDS-32M Round-Hole DS-32M Square-HoleChannel, Rack Front Channel, Rack/Cabinet Front9. Repeat steps 1 through 8 for the other rail Installing the DS-16M2and DS-32M2Switches Mounting Bracket InstallationFan end of switch Installing the Switch in the Rack/CabinetAlign middle hole first C channel Installing the DS-16M2and DS-32M2SwitchesAlign hole in bracket with hole in the fixed rail Installing the DS-16M2and DS-32M2Switches Secure cords with retainer clip Installing the DS-16M2and DS-32M2SwitchesRun cables down trough Trademark Information Installing the DS-16M2and DS-32M2Switches