Kraftware Corporation DS-32M2, DS-16M2 Secure cords with retainer clip, Run cables down trough

Installing the DS-16M2 and DS-32M2 Switches

NOTE: There is a 3-inch space between the front of the switch and the back of the bezel. This is enough room to loop the cord up without pushing the bezel off.

12.When installing the DS-32M2 switch, the 2U spacing allows you to run the power cords between the switches.

13.Secure the power cords in the retainer clips, and route them down the trough along the edge of the rear of the rack. See the figures below.

Secure cords with retainer clip

Run cables down trough

14. Plug the other end into available receptacles on the PDU.

EMC Departmental Switches DS-16M2 and DS-32M2 Installation Guide

21