Kyocera S-9100DN manual e-MPS

Chapter 3 Using the Operator Panel

9	When the desired maximum number of jobs is set,
	press the ENTER key.
10
	Press the MENU key. The display returns to Ready.

QMaximum Space Assigned to Temporary Code Jobs

This changes the hard disk space that holds temporary code jobs. You can change the maximum space from 0 to 9999 (megabytes). The actual maximum size depends on the size of free hard disk space, however. The default size is 1/6 of the to- tal hard disk space, rounded off in units of 50 MB. For example, if the total hard disk space is 3.2 GB, the default size is 500 MB.

1	Press the MENU key.
2	pears.Press the 3 or 4 key repeatedly until e-MPS		> ap-
	e-MPS	>
3
	Press the 2 key.
4	Press the 3 or 4 key repeatedly until >e-MPS		Con-
	figuration > appears.
	>e-MPS	>
	Configuration
5
	Press the 2 key.
6	Press the 3 or 4 key repeatedly until >>Temp. Code
	JOB Size appears.
	>>Temp. Code JOB
	Size	0500MB
7
	To change the maximum disk space, press the ENTER
	key. A blinking cursor (_) appears.
	>>Temp. Code JOB
	Size
		0500MB
8
	Press the 3 or 4 key to increase or decrease, respec-
	tively, the value at the blinking cursor. Use the		2 and
	1 keys to move the cursor right and left.
9	key.When the desired size is displayed, press the ENTER
10
	Press the MENU key. The display returns to Ready.

QMaximum Space Assigned to Permanent Code Jobs

This changes the hard disk space that holds permanent code jobs. You can change the maximum space from 0 to 9999 (megabytes). The actual maximum size depends on the size of free hard disk space, however. The default size is 1/6 of the to- tal hard disk space, rounded off in units of 50 MB. For example, if the total hard disk space is 3.2 GB, the default size is 500 MB.

1	Press the MENU key.
2	Press the 3 or 4 key and select e-MPS >.
	e-MPS	>
3
	Press the 2 key.
4	Press the 3 or 4 key repeatedly until >e-MPS Con-
	figuration > appears.
	>e-MPS	>
	Configuration
5
	Press the 2 key.
6	Press the 3 or 4 key and select >>Perm. Code JOB
	Size.
	>>Perm. Code JOB
	Size	0500MB
7
	Press the ENTER key, the message display shows a
	blinking cursor (_).
	>>Perm. Code JOB
	Size
			0MB
		050
8
	Press the 3 or 4 key to increase or decrease, respec-
	tively, the value at the blinking cursor. Use the 2 and 1
	keys to move the cursor right and left.
9	key.When the desired size is displayed, press the ENTER
10
	Press the MENU key and the message display returns
	to Ready.

3-17