Kyocera S-9100DN manual Using the Operator Panel, Interface, 3-20

Chapter 3 Using the Operator Panel

9 Displaykey. the desired baud rate and press the ENTER

6	Press the 2 key. Each time the 3 or 4 key is pressed,
	the display changes as shown below.

10 Press the MENU key. The message display returns to Ready.

QChanging Network Interface Parameters This printer is equipped with the network interface.

For details on networking, refer to the “Quick Configuration Guide”.

1	Press the MENU key.
2	Press the 3 or 4 key repeatedly until Interface >
	appears. One of the interface names shown below ap-
	pears, indicating the current interface.
	Parallel (default)
	Serial
	Network
	Option (only when an optional network interface
		card is installed)
3	pears.Press the ENTER key. A blinking question mark (?) ap-
	Interface
		?Parallel

>NetWare On

>TCP/IP On

>EtherTalk Off

>Network Status Page On

>Opt. StatusPage On

If turns ON, print the standard Network Inter- face Status Page after the Printer Status Page. See page 3-10.

If turns ON, print the op- tional Network Interface Status Page after the Printer Status Page. See page 3-10.

4	pears.Press the 3 or 4 key repeatedly until Network ap-
	Interface
5		?Network
	Press the ENTER key again.

7	The following example explains how to activate TCP/IP
	protocol to connect the printer in the network. You can
	select Netware or EtherTalk in a similar manner.
	>TCP/IP	>
	On

If TCP/IP is currently displays Off, select On using the

3or 4 key. Press the ENTER key again.

>TCP/IP ? Off

>TCP/IP	>
On

3-20