Land Pride
Section 2 Operating
Table of Contents
IMPORTANT: The engine starter should not be operated for periods longer then 30 seconds at a time. An interval of at least two minutes should be allowed between such cranking periods to protect the starter from overheating and
5.Perform test to make sure safety start interlock system is operating properly. Refer to “Safety Start Interlock System” on page 10.
6.As soon as engine begins to run, check to make certain the oil warning light is off. If not, stop engine immediately and check for the cause. Refer to “Section 7 Troubleshooting” on page 37.
7.Allow the engine to idle a few minutes before advancing the throttle and/or engaging the blade clutch.
8.Before stopping the engine, place the control levers in the brake position, disengage the blade engagement, and throttle back to low idle for a couple of minutes; then rotate ignition key
!WARNING!
Never leave the machine unattended with key in ignition switch.
IMPORTANT: Following repairs, always make certain the two bypass valve stems are returned to their operating position before running the mower.
Driving the Mower
!DANGER!
Never make sudden stops or sudden reversing of direction, especially when going down a slope. The steering is designed for sensitive response. Rapid movement of the control levers in either direction could result in a reaction of the mower that can cause serious injury.
Steering
Refer to Figure 2-8 on page 12
After starting engine, engage the control levers and steer as follows:
•To Go Forward:
Push control levers forward an equal distance.
•To Go in Reverse:
Pull control levers rearward an equal distance.
•To Turn Left:
Move the right control lever farther forward from neutral than the left control lever.
Moving Mower with Stalled Engine
Refer to Figure 2-7
The mower
Before moving the unit, turn each bypass valve stem counter clockwise
Do not tow the machine. Move it by hand or use a winch to load it on a trailer for transporting.
When transporting on another vehicle, the tractor should be facing forward and it must be secured.
•To Turn Right:
Move the left control lever farther forward from neutral than the right control lever.
•To Pivot Turn:
Move one control lever forward and the other control lever back of neutral, this will allow the drive wheels to counter- rotate.
Controlling the Speed
!WARNING!
In the event of a system failure while mowing, engage both parking brakes to stop or slow mower. Refer to Figure
Bypass valve
21054
Bypass Valve
Figure
!DANGER!
When going in reverse push forward gently on control levers and avoid sudden movement. Any sudden movement could cause the front of the mower to come off of the ground resulting in possible loss of control.
To Stop or decrease speed:
Move control levers to neutral. When going forward pull back gently on control levers. When going in reverse push forward gently on control levers.
To Increase Speed:
Increase control levers equal distance from neutral. The farther forward control levers are from neutral, the faster the mower will travel forward. The farther back the control levers are from neutral, the faster the mower will go in reverse.
7/14/08 | ZRP44 & ZRP52 Zero Turning Radius Mowers | 11 |
