Land Pride ZRP44 Refer to -11, -12,and Figure, Table of Contents, Maintenance and Lubrication

Land Pride Table of Contents

Section 4 Maintenance and Lubrication

Deck Drive Belt

1.Park the unit on a flat surface. Stop the engine and remove the ignition key. Make sure blade engagement switch is in the down (OFF) position. Place control levers in the park brake position. Disconnect negative battery cable.

2.Place the deck in the lowest position.

3.Remove the deck belt covers and floor panel.

4.Release the deck belt tension by pulling on the belt tension chain and sliding the chain out of the anchor bracket slot. This will relieve the tension on the deck belt idler spring. Refer to Figure 4-11.

5.Pull the idler to the left of the machine to provide maximum belt clearance.

6.Remove the existing belt and replace with a new belt.

7.Route the new belt per Figure 4-11.

8.Re-tension the deck belt idler per the deck drive belt adjustment section on page 18.

9.Re-install the deck belt covers.

10.Re-attach the negative battery cable and floor panel.

Integrated Pump/Motor Drive Belt

Refer to Figure 4-11, Figure 4-12, and Figure 4-13

Replace hydraulic pump motor drive belt as follows:

1.Park the unit on a flat surface. Stop the engine and remove the ignition key. Make sure blade engagement switch is in the down (OFF) position. Place control levers in the park brake position. Disconnect negative battery cable.

2.Place the deck in the lowest position.

3.Refer Figure 3-13 on page 18 and Figure 4-11on this page. Release the deck belt tension by pulling on the belt tension chain and sliding the chain out of the anchor bracket slot.

4.Remove deck drive belt from the electric clutch pulley mounted to the engine. This belt does not need to be removed from any of the other pulleys.

5.Release the tension from the integrated pump/motor belt by pulling on the idler pulley extension spring carefully until the belt can be slide over the idler pulley. Use caution when releasing the idler pulley as there is still tension on it and it will snap back into position.

5

2

3

6

1

21077

2

42

5

Deck Belt Drive Layout

1.Spindle drive belt

2.Deck blade spindle pulley

3.Spindle belt tension idler

4.Spindle belt tension idler spring (9.0” at operation)

5.Deck belt idler

6.Idler arm

Pump Belt Layout
1.	Pump belt
2.	Engine pulley
3.	Pump idler pulley
4.	Pump idler arm
5.	Pump pulley
6.	Electric Deck Clutch
7.	Pump idler spring
		1
		5
		4
	5
	2,6	7
21078		3

Deck Belt Drive Layout	Mower Viewed from Bottom Deck
Figure 4-11	Figure 4-12

7/14/08 ZRP44 & ZRP52 Zero Turning Radius Mowers 356-117M 31