Table of Contents
Section 4 Maintenance and Lubrication
Land Pride
Burnishing the Electric Clutch
Refer to Figure 4-3
!WARNING!
Figure 4-3WARNING: To insure maximum performance and life, it is necessary to burnish the clutch
Burnishing the electric clutch (Fig.
Use the following procedure to burnish the clutch:
1.Check the air gap between armature and rotor. Gap should be .012 to .024.
2.Cycle the clutch on and off 10 times (15 seconds on and 15 seconds off) with the engine operating at half throttles, approximately 1500 rpm.
Electric Clutch
21062
Electric Clutch
Figure
Seat Platform Latch
21062
Seat Platform Latch
Figure
Seat Platform Catch
21065
Access to Integrated Pump/Motor
Figure
!WARNING!
Always wear adequate eye protection when servicing the hydraulic system and battery.
Access to Engine & Hydraulic Pumps
Refer to Figure 4-5
The pump units are accessed under the seat platform. Raise the seat platform by releasing the seat latch and tilting the seat platform up and forward about its hinged front. A seat platform catch will prevent the seat from going all the way over. Release the seat platform catch if more room under the seat is needed and pivot the seat further forward.
IMPORTANT: Make certain to place the control arms in the park brake position and pivot the arm rests upward before placing the seat platform in the forward position.
Hydraulic System
Refer to Figure 4-6
!WARNING!
Hydraulic oil escaping under pressure can penetrate skin. Hydraulic oil may cause infection in a minor cut or opening in the skin. If exposed to hydraulic fluid, see a doctor at once. Before applying pressure to hydraulic system, make sure all connections are tight and all hoses and lines are in good condition. To find a leak under pressure, use a piece of cardboard or wood never use your hands. Relieve all pressure in the system before disconnecting or working on hydraulic lines. To relieve pressure, lower all attachments and shut off engine.
26 ZRP44 & ZRP52 Zero Turning Radius Mowers | 7/14/08 |
