Lanier GX3050 manual Moving a Short Distance, Moving a Long Distance, 127

Maintaining

Moving

The precautions when moving the printer a short distance or long distance are explained.

Moving a Short Distance

The precautions when moving the printer a short distance or long distance are explained.

zThe Machine weighs approximately 14.5 kg (32.0 lb.).

zWhen moving the machine, hold the machine by the bottom below the two indentations. Lift the machine slowly in order to avoid straining your body. Lifting the machine without sufficient strength or assistance or handling it roughly and dropping it could cause an injury.

z

z

Unplug the power cord from the wall outlet before you move the machine. While moving the machine, you should take care that the power cord will not be damaged under the machine.

When you disconnect the power plug from the wall outlet, always pull the plug (not the cable).

1.Turn the power off, disconnect the USB cable and Ethernet cable, and then unplug the power cord from the wall outlet.

2.Lift the printer using the indents on the printer's sides near the base, and then slowly lift and move the printer without tilting.

Moving a Long Distance

1.Turn the power off, disconnect the USB cable and Ethernet cable, and then unplug the power cord from the wall outlet. Do not remove the print cartridges. Remove the paper.

2.Pack the printer for transport when moving it a long distance such as when changing office or residence. Disconnect all cables, place the printer in the box it was in when purchased, and trans- port in a level manner. After moving the printer, first remove and then reattach the network inter- face board.

127