6. Insert the filler panel into the bay to cover the drive.
Notes:
1.If a RAID controller or adapter is installed, you might have to reconfigure the disk arrays after you install hard disk drives. See your RAID controller or adapter documentation.
2.To remove a
If you have other devices to install, do so now. Otherwise, go to “Completing the installation” on page 24.
Installing a hot-swap hard disk drive
The
The installation procedure is the same for any of these drives. The illustrations in this procedure show
To install a
Note: If you have only one hard disk drive, install it in the left or
Chapter 2. Installing optional devices 17