Lenovo 6435, 6438, 6437, 6436 manual Adapter bracket, Expansion-slotbracket

Attention: When you install an adapter, make sure that it is completely and correctly seated in the expansion slot in the riser card. Incomplete insertion might cause damage to the riser card, system board, or the adapter when you turn on the server.

7.Carefully grasp the adapter by its top edge or upper corners and align it with the expansion slot in the riser card assembly; then, press the adapter firmly into the expansion slot.

1	Adapter bracket	3	Tab
2	Expansion-slot bracket	4	Adapter

Important: Make sure that the U-shaped opening in the metal adapter bracket engages the tab on the expansion-slot bracket.

8.Follow the cabling instructions, if any, that come with the adapter.

9.Reinstall the riser-card assembly. Make sure that the riser-card assembly is fully seated in the riser-card connectors on the system board.

10.If you have installed an optional PCI-X riser-card assembly in the server, reconnect the riser-card power cable
1 to the riser-card assembly.

11.If you are installing a ServeRAID-MR10i controller (2.5-inch drive models only), complete the following steps:

Chapter 2. Installing optional devices 21