Lenovo 6436, 6438, 6437, 6435 manual Remove the filler panel from the bay

Table 2. Locations of hard disk drive IDs

3.5-inch drive model servers

2.5-inch drive model servers

Attention: To avoid damage to the hard disk drive connectors, make sure that the cover is in place and fully closed whenever you install or remove a hard disk drive.

Installing a simple-swap Serial ATA hard disk drive

Attention: Simple-swap hard disk drives are not hot-swappable. Disconnect all power from the server before you remove or install a simple-swap hard disk drive.

To install a simple-swap Serial ATA hard disk drive, complete the following steps.

Note: If you have only one hard disk drive, install it in the left drive bay.

1	SATA hard disk drive back plate	3	Hard disk drive assembly
2	Filler panel

Attention: To avoid damage to the hard disk drive connectors, make sure that the cover is in place and fully closed whenever you install or remove a hard disk drive.

1.Read the safety information that begins on page v and “Installation guidelines” on page 11.

2.Make sure that the server cover is in place and fully closed.

3.Turn off the server and peripheral devices, and disconnect the power cord and all external cables.

4.Remove the filler panel from the bay.

5.Pull the loops of the tray toward each other and slide the drive into the server until the drive connects to the back panel.

16ThinkServer RS110 Types 6435, 6436, 6437, and 6438: Installation Guide