Lenovo 8177, 8084, 8149, 8085, 8148, 8147, 8179 Replacing FRUs Types 8126, 8174, 8175, and 8176

Note: This illustration shows the hard disk drive being removed. All drives are removed in the same manner. However, it is only necessary to remove the front bezel when removing the hard disk drive or diskette drive.

7.Make sure the drive that you are installing is set correctly as either a master or a slave device. Jumper the new drive the same as the drive being replaced.

Note: If you are installing a serial ATA drive, no master/slave jumpering is necessary.

Refer to the documentation that comes with your drive for master/slave jumper information.

8.Install the new drive into the bay. Align the screw holes and install the screws to secure the drive.

Chapter 8. Replacing FRUs (Types 8126, 8174, 8175, and 8176) 103