Lenovo 8126, 8177, 8175 XXX Remove USB devices and re-test, XXX System board, XXX Information only

Diagnostic Error Code	FRU/Action
015-034-XXX	1.	Reboot the system
USB port buffer
	2.	Flash the system and re-test. See “Flash
allocation failure
		update procedures” on page 214
	3.	Run memory test
	4.	System board
015-035-XXX	1.	Remove USB device(s) and re-test
USB port Reset condition detected
	2.	System board
015-036-XXX	System board
USB port Register error
015-040-XXX	1.	Run setup and check for conflicts
USB port IRQ failure
	2.	Flash the system. See “Flash update
		procedures” on page 214
	3.	System board
015-195-XXX	Information only
USB port Test aborted by user	Re-start the test, if necessary
015-196-XXX	1.	Press F3 to review the log file
USB port test halt, error threshold exceeded
	2.	Re-start the test to reset the log file
015-197-XXX	1.	Make sure the component that is called
USB port test warning
		out is connected and/or enabled. See
		Chapter 6, “Using the Setup Utility,” on
		page 55
	2.	Re-run test
	3.	Replace the component that is called out
		in warning statement
	4.	Replace the component under test
015-198-XXX	1.	If a component is called out, make sure
USB port test aborted
		it is connected and/or enabled. See
		Chapter 6, “Using the Setup Utility,” on
		page 55
	2.	Flash the system and re-test. See “Flash
		update procedures” on page 214
	3.	Go to “Undetermined problems” on page
		90
015-199-XXX	1.	Go to “Undetermined problems” on page
USB port test failed, cause unknown
		90
	2.	Flash the system and re-test. See “Flash
		update procedures” on page 214
	3.	Replace component under function test
018-000-XXX	No action
PCI Card Test Passed
018-0XX-XXX	1.	Riser card, if installed
PCI Card Failure
	2.	System board
018-195-XXX	1.	PCI card
PCI Card Test aborted by user
	2.	Information only
		Re-start the test, if necessary

70Hardware Maintenance Manual