5.For all drives except the hard disk drive, push in on the metal tab that secures the drive being removed. The hard disk drive tray pivots out toward the front of the computer for removal of the hard disk drive. See the following illustrations.

For the hard disk drive, see the illustration below.

6.Slide the drive out the front of the computer.

7.Make sure the drive that you are installing is set correctly as either a master or a slave device. Jumper the new drive the same as the drive being replaced.

Note: If you are installing a serial ATA drive, no master/slave jumpering is necessary.

Refer to the documentation that comes with your drive for master/slave jumper information.

8.Slide the drive into the appropriate bay.

9.Reconnect the signal and power cables to the new drive.

132Hardware Maintenance Manual

Page 138
Image 138
Lenovo 8148, 8177, 8175, 8084, 8149, 8126, 8085, 8147, 8176, 8174, 8179, 8178 manual Hardware Maintenance Manual