Lenovo 8084, 8177 XXX Press F3 to review the log file, XXX Make sure the component that is called

Diagnostic Error Code	FRU/Action
011-195-XXX	Information only
Serial port Test aborted by user	Re-start the test, if necessary
011-196-XXX	1.	Press F3 to review the log file
Serial port test halt, error threshold exceeded
	2.	Re-start the test to reset the log file
011-197-XXX	1.	Make sure the component that is called
Serial port test warning
		out is connected and/or enabled. See
		Chapter 6, “Using the Setup Utility,” on
		page 55
	2.	Re-run test
	3.	Replace the component that is called out
		in warning statement
	4.	Replace the component under test
011-198-XXX	1.	If a component is called out, make sure
Serial port test aborted
		it is connected and/or enabled. See
		Chapter 6, “Using the Setup Utility,” on
		page 55
	2.	Flash the system and re-test. See “Flash
		update procedures” on page 214
	3.	Go to “Undetermined problems” on page
		90
011-199-XXX	1.	Go to “Undetermined problems” on page
Serial port test failed, cause unknown
		90
	2.	Flash the system and re-test. See “Flash
		update procedures” on page 214
	3.	Replace component under function test
011-2XX-XXX	1.	External serial device
Serial port signal failure
	2.	System board
014-000-XXX	No action
Parallel port Interface Test Passed
014-001-XXX	1.	Remove external parallel device, if
Parallel port Presence
		present
	2.	Run setup, enable port
	3.	System board
014-002-XXX	System board
014-003-XXX
Parallel port Timeout/Parity error
014-013-XXX	System board
014-014-XXX
Parallel port Control Signal/Loopback test
failure
014-015-XXX	1.	Wrap plug
Parallel port External Loopback failure
	2.	System board
014-027-XXX	1.	Run Setup, enable port
Parallel port Configuration/Setup error
	2.	Flash the system. See “Flash update
		procedures” on page 214
	3.	System board

68Hardware Maintenance Manual