Lenovo NVS-4200M, 42825BU Setting management features, Resume on incoming call, Asset ID Eeprom

Resume on incoming call

If your computer is connected to a telephone line and you have specified Resume on incoming call, it will return from sleep (standby) mode to normal operation when a telephone call comes in.

To enable your computer to wake up from sleep (standby) mode, do the following:

For Windows 7 and Windows Vista:

1.Click Start, and then click Control Panel.

2.Click Hardware and Sound.

3.Click Device Manager. If you are prompted for an administrator password or confirmation, type the password or provide confirmation. The Device Manager window opens.

4.Double-click Modems (in Windows Vista, click the + mark for Modems), and then click your modem.

5.Click the Power Management tab.

6.Select the Allow this device to wake the computer check box.

For Windows XP:

1.Click Start, and then click Control Panel.

2.Click Performance and Maintenance.

3.Click System.

4.Click the Hardware tab.

5.Click the Device Manager button. The Device Manager window opens.

6.Click the + mark for Modems, and then click your modem.

7.Click Action, and then click Properties.

8.Click the Power Management tab.

9.Select the Allow this device to bring the computer out of Standby check box.

Asset ID EEPROM

The Asset ID EEPROM contains information about the system, including its configuration and the serial numbers of key components. It also includes a number of blank fields in which you can record information about the end users in your network.

Setting management features

To enable the network administrator to control your computer remotely, you must configure the network interface by setting the system-management features in the ThinkPad Setup program. You can configure the following:

•Wake on LAN

•Network Boot sequence

•Flash update

If an administrator's password (supervisor password) has been set, you will need to specify it when you start the ThinkPad Setup, so that you can use these functions.

Wake on LAN

When the Wake on LAN feature is enabled on a computer that is connected to a LAN, a network administrator can start the computer remotely from a management console, using remote network-management software.

218User Guide