Lenovo NVS-4200M, 42825BU, 4242X04, 42421A0 manual Register Description Range Units

To change the value of an S register, use the command ATSr=n where r is a register number 0-110, and

n is the new value you want to assign. For example, to change the value of S0 register to 20 rings, type ATS0=20 and press Enter.

Refer to the following table of S registers:

Table 5. S registers

Register	Description	Range	Units
S0	Number of Rings to Automatic	0-255	Rings
	Answer.
S1	Ring Counter	0-255	Rings
S2	Escape Character	0-255 ASCII Decimal	ASCII
S3	Line Termination Character	0-127 ASCII Decimal	ASCII
S4	Response Formatting	0-127 ASCII Decimal	ASCII
	Character
S5	Command Line Editing	0-32 ASCII Decimal	ASCII
	Character
S6	Wait Time for Dial Tone Before	2-255	s
	Blind Dialing, or After “W” Dial
	Modifier
S7	Wait Time for Carrier After	1-255	s
	Dial, for Silence, or for Dial
	Tone After “W” Modifier
S8	Pause Time for Dial Delay	0-255	s
	Modifier (,)
S10	Carrier Loss Disconnect Time	1-255	0.1s
S11	DTMF Tone Duration	50-255	0.001s
S12	Escape Prompt Delay	0-255	0.02s
S18	Test Timer	0-255	s
S29	Flash Dial Modifier Time (!)	0-255	10ms
S30	Disconnect Inactivity Timer	0-255	10s
S46	Data Compression Control	136 (no compression) or 138
		(compression)
S95	Result Code Messages
	Control:
	Bit 0 CONNECT result
	code indicates DCE speed
	instead of DTE speed.
	Bit 1 Reserved.
	Bit 2 Enable
	+MCR:XXXX result code
	(XXXX=modulation) and
	+MRR:XXXX result code
	(XXXX=rate). (See +ER.).
	Bit 3 Enable
	+ER:XXXX result code
	(XXXX=protocol identifier).
	(See +ER.).
	Bit 4 Reserved.

74User Guide