![](/images/new-backgrounds/1116707/116707239x1.webp)
Hinge pin
Rear adapter retention bracket
6.If necessary, remove the Remote Supervisor Adapter II SlimLine retention tab and store it for future use.
Installing the rear adapter retention bracket
To install the rear
1.If you removed the Remote Supervisor Adapter II SlimLine retention tab earlier, reinstall it on the rear
2.Position the rear adapter retention bracket so that the hole in one of the hinge points is aligned with the hinge pin on the chassis; then, place the hinge pin through the hole on the chassis.
3.Rotate the rear
4.Install the side cover (see “Installing the side cover” on page 63).
5.Lock the side cover if you unlocked it during removal.
6.Reconnect the external cables and power cords; then, turn on the attached devices and turn on the server.
Removing the front adapter-retention bracket
To remove the front
1.Read the safety information that begins on page vii and “Installation guidelines” on page 57.
2.Turn off the server and all attached devices; then, disconnect all power cords and external cables.
3.Unlock and remove the side cover (see “Removing the side cover” on page 62).
4.Open the front and rear
5.Remove all adapters (if necessary) and place them on a
Note: You might find it helpful to note where each adapter is installed before you remove the adapters.
6.Grasp one side of the bracket at a hinge point and pull outward (while you rotate the bracket slightly toward the rear of the server) until the hinge pin on the bracket is free of the hole; then, grasp the bracket on the other side at the hinge point, pull outward until the bracket is free of the hinge pin, and remove the rear
102ThinkServer TS100 Types 6431, 6432, 6433, and 6434: Hardware Maintenance Manual