Lenovo 6433, TS100, 6434, 6432, 6431 manual ENETeee IP-CfgHstName=x Information only

1. Make sure that fan x is not obstructed.

2. Reseat the fan x cable.

3. Replace fan x.

vFollow the suggested actions in the order in which they are listed in the Action column until the problem is solved.

vSee Chapter 3, “Parts listing, ThinkServer TS100 Machine Types 6431, 6432, 6433, and 6434,” on page 37 to determine which components are customer replaceable units (CRU) and which components are field replaceable units (FRU).

vIf an action step is preceded by “(Trained service technician only),” that step must be performed only by a trained service technician.

System-error log message	Action
ASM Reset -- reason unknown	Information only.
ASM Reset due to x, Instruction Fault: y	Information only.
ASM Reset due Watchdog timeout	Information only.
ASM Reset was caused by restoring default	Information only.
values
ASM Reset was initiated by the user	Information only.
Configuration error recovery on the Inter-connect	Information only.
network
CPU over temperature	1.	Make sure that the fan sink has good airflow and is not
		obstructed.
	2.	Reseat the following components:
		a. Fan-sink cable
		b. (Trained service technician only) Fan sink
DASD controller removal	1.	Make sure that the mini-PCI-X adapter cable is not damaged.
	2.	Reseat the mini-PCI-X adapter cable.
	3.	Replace the mini-PCI-X adapter cable.
DHCP failure,no IP@ assigned-	Information only.
RETRYING!,rc=xxx,count=yyy
Dialback failed for userid w. Could not connect	Information only.
at phone number x, y, z
ENET[eee] DHCP-	Information only.
HstNme=a,DN=b,IP@=ccc.ccc.ccc.ccc
GW@=ddd.ddd.ddd.ddd, NMsk=fff.fff.fff.fff,
DNS1@=ggg.ggg.ggg.ggg,
DNS2@=hhh.hhh.hhh.hhh
ENET[eee] IP-Cfg:HstName=x,	Information only.
IP@=ccc.ccc.ccc.ccc, GW@=ddd.ddd.ddd.ddd,
NetMsk=fff.fff.fff.fff
Failure reading an I2C device, possible bus	1.	Reseat the following components:
failure
		a. AC power cords
		b. Hot-swap power supplies, if any are installed
		c. Power-supply cables on the system board
	2.	(Trained service technician only) Replace the system board.
Fan x Failure	1.	Make sure that fan x is not obstructed.
	2.	Reseat the fan x cable.
	3.	Replace fan x.
Fan x Outside Recommended Speed

236ThinkServer TS100 Types 6431, 6432, 6433, and 6434: Hardware Maintenance Manual