Lenovo 6433, TS100, 6434, 6432, 6431 manual 166-803-xxx

Table 12. Diagnostic messages (continued)

vFollow the suggested actions in the order in which they are listed in the Action column until the problem is solved.

vSee Chapter 3, “Parts listing, ThinkServer TS100 Machine Types 6431, 6432, 6433, and 6434,” on page 37 to determine which components are customer replaceable units (CRU) and which components are field replaceable units (FRU).

vIf an action step is preceded by “(Trained service technician only),” that step must be performed only by a trained service technician.

Message
number	Component	Test	State	Description	Action
166-803-xxx	BMC	BMC I2C Test	Aborted	BMC I2C test	1.	Turn off the system and disconnect it
				canceled: the
						from the power source. You must
				node is busy; try
						disconnect the system from ac power to
				later.
						reset the BMC.
					2.	After 45 seconds, reconnect the system
						to the power source and turn on the
						system.
					3.	Run the test again.
					4.	Make sure that the Diagnostic code is
						at the latest level. For the latest level of
						Diagnostic code, go to:
						http://www.lenovo.com/support.
					5.	Make sure that the BMC firmware is at
						the latest level. The installed firmware
						level is shown in the Diagnostic event
						log in the Firmware/VPD section for this
						component. For the latest level of
						firmware, start EasyUpdate or go to:
						http://www.lenovo.com/support and
						select your system to display a matrix
						of available firmware.
					6.	Run the test again.
					7.	If the problem remains, collect the data
						from the Diagnostic event log and send
						it to Lenovo Service. For information
						about contacting Lenovo Service, go to:
						http://www.lenovo.com/support.

176ThinkServer TS100 Types 6431, 6432, 6433, and 6434: Hardware Maintenance Manual