Lenovo 6433, TS100, 6434, 6432, 6431 manual 166-823-xxx

Table 12. Diagnostic messages (continued)

vFollow the suggested actions in the order in which they are listed in the Action column until the problem is solved.

vSee Chapter 3, “Parts listing, ThinkServer TS100 Machine Types 6431, 6432, 6433, and 6434,” on page 37 to determine which components are customer replaceable units (CRU) and which components are field replaceable units (FRU).

vIf an action step is preceded by “(Trained service technician only),” that step must be performed only by a trained service technician.

Message
number	Component	Test	State	Description	Action
166-823-xxx	BMC	BMC I2C Test	Aborted	BMC I2C test	1. Turn off the system and disconnect it
				canceled: cannot
					from the power source. You must
				execute the
					disconnect the system from ac power to
				command;
					reset the BMC.
				insufficient
					2. After 45 seconds, reconnect the system
				privilege level.
					to the power source and turn on the
					system.
					3. Run the test again.
					4. Make sure that the Diagnostic code is
					at the latest level. For the latest level of
					Diagnostic code, go to:
					http://www.lenovo.com/support.
					5. Make sure that the BMC firmware is at
					the latest level. The installed firmware
					level is shown in the Diagnostic event
					log in the Firmware/VPD section for this
					component. For the latest level of
					firmware, start firmware, go to
					EasyUpdate or go to:
					http://www.lenovo.com/support and
					select your system to display a matrix
					of available firmware.
					6. Run the test again.
					7. If the problem remains, collect the data
					from the Diagnostic event log and send
					it to Lenovo Service. For information
					about contacting Lenovo Service, see
					http://www.lenovo.com/support.

196ThinkServer TS100 Types 6431, 6432, 6433, and 6434: Hardware Maintenance Manual