Lenoxx Electronics Optima 3 FS Installation, Removing Appliance From Pallet, Optima 3 INS

INSTALLATION

REMOVING APPLIANCE FROM PALLET

1.After removing the packaging from the stove, lift the hop- per lid, and remove all pre-packaged items that were shipped in the hopper. Next, open the stove door and remove all pre-packaged items.

2.Using a socket or open end wrench (7/16" for freestand- ing units and 3/8" for the insert), remove the pallet bolts which secure the unit to the pallet (located on each side of back corners and at the front under ash pan). See fol- lowing pictures.

Optima 3 INS

Use a 3/8" nut driver to remove the bolts on both brackets (located on each side of the in- sert back).

Side View of Optima 2 FS & Optima 3 FS

(Removing Back Pallet Bolts)

Remove 1 bolt on each side of stove back

Note: The pallet bolt at the front of appliance is located un- der the ash pan (this will require removing the ash pan. See Ash Pan on pages 28 and 29 for removal instructions). See following picture (freestanding unit shown).

Front View - Removing Front Pallet Bolt

Stove or Insert Front

With the ash pan removed, remove center bolt.

INSTALLATION CHECK LIST

It is strongly recommended that you have an author- ized Lennox Hearth Products dealer install your stove. If you install your stove yourself, you should review your installation plan with an authorized Len- nox Hearth Products dealer.

Check list:

Check off each item as you proceed with the installa- tion process.

Read the ENTIRE stove installation section first Read the Insert or Freestanding section (which- ever applies).

Determine the appropriate measurements and locations for your installation.

Follow the general installation directions under Stove Installation and the installation section ap- propriate to your stove.

Be sure to pre-fit all items before you install, fas- ten, or set up the stove permanently.

Prior to lighting your stove:

Review the Important Warnings section (page 2). Review Fuel Specifications (page 27).

Review and follow instructions in the Care and Operation Section (pages 22 to 27).

Plug power cord connector into corresponding connector on the back of appliance (see illustra- tions on page 13 showing connector locations).

Note: Optima 3 INS – Route power cord behind side surround panel.

After you have begun operation of your stove: Review the routine cleaning / maintenance informa- tion.

Enjoy the warmth from your new Lennox Hearth Products pellet stove!

(Insert Only) It is important to level the appliance. In some installations such as a recessed firebox floor (if the existing fireplace floor is lower than the hearth), install the 2 leveling bolts (1/4-20 x 3” long) into the threaded holes at the rear base of the Optima 3 INS. Adjust bolts until appliance is level.

PAGE 10