Lenoxx Electronics Optima 3 FS operation manual Installation, Remove panels from package

INSTALLATION

INSTALLING SURROUND ASSEMBLY - Optima 3 INS (to be done after venting system is installed)

The surround kit (purchased separately) comes with a set of metal panels that enclose the fireplace opening when fitted together. There is also a trim assembly that frames the surround assembly to give it an attractive fin- ished appearance. Put the surround assembly together according to the following instructions.

1.Remove panels from package.

2.Open the hopper lid on Optima 3 INS so it is out of the way for when panels are installed.

3.Install the control board onto the right side panel (with door) using the TEK screw (#8 x ½”) provided.

4.Position the power cord so that it will be behind either the right or left side surround panel when they are in- stalled.

5.Install right side surround panel onto right side of the Optima 3 INS body by sliding the 2 flanges on side of panel into corresponding slots on the Optima 3 INS.

6.Connect the wiring harness from the Optima 3 INS into corresponding connector on control board.

Locate damper rod on left side of the Optima 3 INS. Ro- tate angled arm of rod so it is pointing down. Remove damper knob and set aside.

7.Install the left-hand panel onto the left side of Optima 3 INS body by sliding the 2 flanges on side of panel into corresponding slots on the Optima 3 INS.

8.Reach behind left surround panel and rotate damper arm so that end is inserted into the upper right hand slot of left surround panel (see illustration on page 12, Optima 3 INS).

9.Reinstall damper knob by threading it onto end of damper rod.

10.Set the top surround panel in place over the two side panels. Position the 2 tabs on bottom of top surround panel so they slide into corresponding clips on the Optima 3 INS. Connect the top surround panel to the side panels by pressing pins from side panels into corresponding holes on top panel.

11.Remove the surround trim from its packaging. As- semble it together using the corner keys (“L” shaped brackets) provided. Slide assembled trim over the top surround panel and slide it down over the side pan- els.

12.Push the Optima 3 INS back into place so the sur- round is flush with the face of the hearth.

PAGE 11