Lenoxx Electronics Optima 3 FS Ash Pan Latch, HEAT EXCHANGER TUBES All Models, Tube Scraper

ROUTINE MAINTENANCE

3.Release both ash pan latches and pull forward. Models Optima 2 FS and Optima 3 FS

Ash

Pan

Latch

Model Optima 3 INS

Ash	Latch
Pan

4.Remove the ash pan. Place ashes into a non- combustible container. When finished, close the glass door and slide the ash pan back into the stove and close the ash pan door. Reinstall ash pan cover panel.

*(Minimum Frequency of 2 days – 2 weeks)

HEAT EXCHANGER TUBES (All Models)

Only Clean Heat Exchanger Tubes When Stove is Cool.

Tube Scraper

After lifting the hopper lid, use the hole in the handle of the Grate Scraper Tool to “grab” onto the rod. Using the Grate Scraper Tool, pull the rod up and out towards the opening of the firebox. Continue pulling until the Tube Scraper reaches the top of the firebox. The rod is located on the outside, above the door. Pull the tube scraper rod out, then repeat 2–3 times to remove fly ash from the heat exchange tubes.

Tube Scraper

Use tool to grab scraper rod.

Tool

Tube

Scraper

Rod

PAGE 29