SPECIFICATIONS - Optima 3 FS
Flue Size
Width, Overall
Depth, Overall
Depth, Overall w / 3” tee
Height
Floor to Rear
Flue Center
Facing Back of Unit, outside edge on right to center of rear flue outlet
Floor to Rear Outside Air Inlet Located on center- line of pedestal back.
Facing Back of Unit outside edge on right to center of air inlet
3” / 76mm Rear | BACK VIEW | ||
25 7/8” |
|
| |
| 25 7/8" |
|
24 7/8” |
|
30 3/4” |
|
31 3/8” |
|
16 7/8” | 31 3/8" |
|
5 1/8”
167/8"
5 1/8"
10” | 8 7/8" |
|
5 1/8" | 12 15/16" |
12 15/16”
Floor Protection Requirements
Standard Features
Hopper Capacity
Burn time
Fuse, Control Board Fuse, Igniter
Heat Input (Max.) Overall Efficiency
Emissions
Ship Weight
Room Air Blower
Auger Motor
Exhaust Blower
Fastfire Igniter
+Front and Side: 6”/152mm
Back: Up to 6” / 152mm
Fastfire Self Igniter Wall Thermostat (wire included)
70 lbs.
♦
5 Amp, 250 volt, 3AG *
6 Amp, 125 volt *
♦
81%
♦.9 gr / hr (varies w / size
and type of fuel) EPA ex- empt
270 lbs.
150 CFM; .8 Amps,
2175 rpm
1 RPM; .4 Amps
95 CFM: 1.0 Amps,
2880 rpm
4.35 Amps,
SIDE VIEW
303/4"
24 7/8"
Note: Dimensions shown are approximations only (+/- ¼”)
+
Options
Nickel or Gold Trim Kits | ♦ Fuel delivery and burn times will vary depending |
4” Quick Disconnect | on size and type of fuel used. Estimated heat input |
Log Set | based on fuel value of 8400 BTU per lb. |
| * Fuses are rated as fast blow. |
PAGE 35