Lexicon MC-12 Mode - Parameter Relationships, Mode Adjust, The parameter, Is used in these modes

MC-12 Mode Adjust

TREB CUT RT 500Hz to 20kHz

Sets the frequency above which high frequencies are rolled off in the reverberated signal, causing reverberated signals to grow progressively darker. This results in a more natural sound because it simulates the effect of air absorption in a real hall. Setting this parameter to a low frequency dampens the audio as it recirculates,

and consequently can actually shorten the reverb time. Available in all LIVE! modes.

VOCAL ENHANCE +6.0dB, +3.0dB, +0.0dB

Controls the level of dialog boost in the audio output connector labeled Center. Increase this setting to improve dialog intelligibility, particularly at lower volume levels. Available in all Logic 7 modes.

MODE – PARAMETER RELATIONSHIPS

The following table lists each parameter and the modes in which it is used.

The parameter...	Is used in these modes
5 SPKR ENHANCE	All L7 modes
ACADEMY FILTER	MONO LOGIC and 5.1 MONO LOGIC
AUTO AZIMUTH	L7 FILM and L7 TV
BASS CONTENT	PANORAMA
BASS ENHANCE	All L7 modes
BASS RT	CHURCH, CATHEDRAL, and all LIVE! modes
BASS XOVER	All LIVE! modes
CALIBRATION	PANORAMA
CENTER	All except 2 CH modes (2-CHANNEL, 2 CH BYPASS, DTS (ES) 2-CHAN, 5.1 2-CHANNEL, 5.1a 2-CHANNEL),
	MONO, 5.1 MONO, and LIVE! modes

5-45