Lexicon MC-12 manual Restoring Factory-Defaultsettings, Troubleshooting & Maintenance

Troubleshooting & Maintenance Lexicon

RESTORING FACTORY-DEFAULT SETTINGS

When factory-default settings are restored, all parameters and user-defined values are restored to their factory-default settings. Before restoring factory-default settings, you should record all user-defined settings.

FACTORY SETTINGS	FACTORY SETTINGS
EXIT	HAVE BEEN RESTORED
RESTORE DEFAULTS	PRESS ANY KEY
	TO RESTART

To restore factory-default settings:

1.Select one of the following options to record user defined settings:

•Use the Configuration Tool to download current MC-12 set- tings to a personal computer (PC). The configuration tool is available at www.lexicon.com/mc12/downloads. asp.

•Record user-defined settings on the installation worksheet that begins on page A-20.

2.If applicable, press the Standby Button to activate standby mode.

3.When standby mode is activated, press the Standby Button to deactivate standby mode.

4.After the Standby Button is pressed, quickly press and hold the Mute button until the FACTORY SETTINGS menu shown above opens on the on-screen and front panel displays.

Note:

The Mute button must be pressed within 2 seconds of deac- tivating standby mode. Otherwise, the "MUTE ON" message will appear on the on-screen and front panel displays. If this occurs, too much time has passed. Begin again with step 2.

5. Press the	and	arrow buttons to highlight the desired
option.

•Highlight RESTORE DEFAULTS to restore factory default settings.

•Highlight EXIT to close the FACTORY SETTINGS menu without restoring factory-default settings.

6. When the desired option is highlighted, press the	arrow
button to select this option.

•If the RESTORE DEFAULTS option was selected, the FAC- TORY SETTINGS message shown on the previous page will appear on the on-screen and front panel displays. When this message appears, press a front panel or remote control but- ton to restart the MC-12.

•If the EXIT option is selected, the FACTORY SETTINGS menu will close and the two-line status will open on the on-screen and front panel displays

6-4