24xx
9.Unhook the spring clip [A] from the left end of the lower pinch roller shaft and push it off the gray slotted spring block [B] toward the back of the printer, as shown.
10.Slide the carrier to the center of the printer.
11.Slide the gray slotted spring blocks [B], on each end, toward the center of the roller shaft, taking care that the blocks remain with the shaft during removal.
12.Slide the carrier to the right side of the printer.
13.While holding the lower pinch roller shaft by the gear [C], move the shaft to the left approximately one half inch. Lift the shaft up and to the back of the printer and carefully remove the lower pinch roller and shaft.
14.Be sure to perform the
