Lexmark 24XX-100 manual Go to Carrier Service Check, Home Position Error Without

24xx

LED	Status	Alarm	Action
Power	ON	Beeps	Home Position Error
Ready	Blinking	10	Go to “Carrier Service Check”
Paper Out	Blinking	times
			on page 2-16.
Panel Lock	Blinking
Font Lock	Blinking		Tractor 2 Home Position Error
			If Tractor 2 is installed, remove it
			to determine whether the problem
			is with the carrier home position
			sensor or the Tractor 2 home
			position sensor. See the “Tractor
			2 Service Check” on page 2-33.
		None	Home Position Error Without
			Alarm
			Go to “Power Service Check”
			on page 2-27.
Power	ON	None	Timer Error
Ready	Blinking		Turn the printer off and then back
Tractor 2	Blinking
			on. If you get the same error
Paper Out	Blinking
			during power-up, replace the logic
Font Lock	Blinking
			board and readjust the
			bidirectional print adjustment.
			Go to “Bidirectional Print
			Adjustment” on page 4-4.
Power	ON	None	Hardware Drive Error
Ready	Blinking		The printhead or the printhead
Tractor 2	Blinking
			cable(s) can cause this error. Go
Paper Out	Blinking
			to “Printhead Service Check”
Font Lock	Blinking
			on page 2-29.
			Turn the printer off and then back
			on. If you get the same error,
			replace the logic board and
			readjust the “Bidirectional Print
			Adjustment” on page 4-4.
			If the printer completes POST
			successfully and eventually gets
			the same error, go to
			“Intermittent Problem Service
			Check” on page 2-18.

Diagnostic Information 2-3