LG Electronics 55WT30MS English, Controlling The Multiple Product, Tile H Size Command d g

90CONTROLLING THE MULTIPLE PRODUCT

ENGLISH

43.Tile V Position (Command: d f) To adjust the Tile Vertical position.

*This function is available only when the Natural option of the Tile Mode is set to Off while the Tile Mode set to On.

Transmission

[d][f][ ][Set ID][ ][Data][Cr]

Data 0 to 32: 0 (Bottom) to 50 (Top)

*Bottom/Top values depend on Tile Vertical size.

**It may not be supported depending on the model.

Acknowledgement

[f][ ][Set ID][ ][OK/NG][Data][x]

44.Tile H Size (Command: d g)

To adjust the Tile Horizontal Size.

*Set Tile H Position to 0x32 before setting Tile H Size.

*This function is available only when the Natural option of the Tile Mode is set to Off while the Tile Mode set to On.

Transmission

[d][g][ ][Set ID][ ][Data][Cr] Data 00 to 32: 0 to 50

**It may not be supported depending on the model. Acknowledgement

[g][ ][Set ID][ ][OK/NG][Data][x]

46.Natural Mode (In Tile Mode) (Command : d j)

To display the image naturally, the part of the image that would normally be displayed in the gap between the monitors is omitted.

Transmission

[d][j][ ][Set ID][ ][Data][Cr] Data 00: Off

01:On

Acknowledgement

[j][ ][Set ID][ ][OK/NG][Data][x]

47.DPM Select (Command: f j)

To set the DPM (Display Power Management) function.

Transmission

[f][j][ ][Set ID][ ][Data][Cr] Data 00: Off

01:On

*Data settings may vary depending on your model as below.

Data 00: Off

01:5 sec.

02:10 sec.

03:15 sec.

04:1 min.

05:3 min.

06:5 min.

07:10 min.

Acknowledgement

[j][ ][Set ID][ ][OK/NG][Data][x]

45.Tile V Size (Command: d h) To adjust the Tile Vertical size.

*Set Tile V Position to 0x00 before setting Tile V Size.

*This function is available only when the Natural option of the Tile Mode is set to Off while the Tile Mode set to On.

Transmission

[d][h][ ][Set ID][ ][Data][Cr] Data 00 to 32: 0 to 50

**It may not be supported depending on the model. Acknowledgement

[h][ ][Set ID][ ][OK/NG][Data][x]

48.FAN Control (Command : d o) To set the Fan mode.

Transmission

[d][o][ ][Set ID][ ][Data][Cr]

Data 00: Auto

01: On

02:Manual

03:Off

**It may not be supported depending on the model.

Acknowledgement

[o][ ][Set ID][ ][OK/NG][Data][x]