LG Electronics 47WT30MS, 55WT30MS, 42WT30MS owner manual Mounting on a Wall, English

ASSEMBLING AND PREPARING 11

Mounting on a Wall CAUTION

For proper ventilation, allow a clearance of 10 cm on each side and from the wall. Detailed installation instructions are available from your dealer, see the optional Tilt Wall Mounting Bracket Installation and Setup Guide.

10 cm

10 cm

10 cm 10 cm

10 cm

If you intend to mount the monitor to a wall, attach a wall mounting interface (optional parts) to the back of the set.

When you install the monitor using a wall mounting interface (optional parts), attach it carefully so it will not fall.

1Please, use a wall mount and screws in accordance with VESA Standards.

2If you use screws longer than standard, the monitor might be damaged internally.

yyDisconnect the power cord first, and then move or install the monitor set. Otherwise electric shock may occur.

yyIf you install the monitor set on a ceiling or slanted wall, it may fall and result in severe injury.

yyUse an authorized LG wall mount and contact the local dealer or qualified personnel.

yyDo not over tighten the screws as this may cause damage to the monitor set and void your warranty.

yyUse the screws and wall mounts that meet the VESA standard. Any damages or injuries by misuse or using an improper accessory are not covered by the warranty.

yyTo prevent injury, this apparatus must be securely attached to the wall in accordance with the instrallation instructions. (This only pertains to Australia and New Zealand.)

NOTE

yyThe wall mount kit includes an installation manual and necessary parts.

yyThe wall mount bracket is optional. You can obtain additional accessories from your local dealer.

yyThe length of screws may differ depending on the wall mount. Be sure to use the proper

ENGLISH

3If you use improper screws, the product might be damaged and drop from mounted position. In this case, LG Electronics is not responsible for damage.

4Please use VESA standard as below.

length.

yyFor more information, refer to the instructions supplied with the wall mount.

yy785mm (31 inch) or greater

*Fastening screw: Diameter 6.0 mm x Pitch 1.0 mm x Length 10 mm