Configuration Options via Command Line
Caution: Do NOT initiate simultaneous menu sessions to run commands. Doing so will interfere with active processes and may corrupt the system configuration and/or cause the HCS6300 card to cease normal operation.
Access the HCS6300 Main Menu
Note: The HCS6300 must be connected to an IP network for Telnet access. For direct access to the HCS6300 Service Port, use the FTDI
1.Establish communication with the HCS6300 using Telnet or via a direct connection to the HCS6300 Service Port.
2.Once communication is established, press Enter to refresh the menu display in the terminal. You now have access to the HCS6300 configuration Main Menu (see example below).
3.At the [Main] Command > prompt, type the desired menu command and press Enter.
Note: You can always press Enter at the [Main] Command > prompt to display the HCS6300 Main Menu. Main Menu options may vary from the example shown, depending on the HCS6300 firmware version.
The following sections describe the configuration commands.
Example: HCS6300 Main Menu
Main Menu | (Copyright 2012 - LGE USA) | |
info | System Information | |
rf | Set RF Channels | |
mrf | Print RF Channels Map | |
list | List Cards | |
card | Card Menu | |
xrst | External Card Reset | |
setip | Set Up IP Address | |
pi | Install PI Key On All Cards | |
pr | Reload PI Key on All Cards | |
upd | Update Firmware | |
bits | Read MUX Bitrates | |
rawbits | Read Bitrates at Backplane Connector | |
crosspt | Configure Card Number to Channel Assignment | |
rstpwd | Reset Password (for Reload PI Key on Web UI) | |
[Main] Command >
31 |
