Configuration Options via Command Line (Cont.)
Satellite Receiver Menu Commands
The following subsections describe how to access and use the Satellite Receiver Menu commands.
Access the Satellite Receiver Menu
1.Access the card menu for the selected transcoder (see “Access the Transcoder Menu” on page 40).
2.At the [Card (#)] Command > prompt, type stb and press Enter.
3. At the [Satellite (#)] Command > prompt, either:
•Press Enter to display the Satellite Receiver Menu (see example below).
•Type the desired command and press Enter.
Note: You can always press Enter at the Command > prompt to display the Satellite Receiver Menu.
Example: Satellite Receiver Menu
Satellite Receiver Menu
getch | Read Current STB Channel |
setch | Set STB Channel |
lksts | Read Satellite Lock Status |
sglvl | Read Satellite Signal Strength |
actsts | Read STB Activation Status |
cnum | Read Access Card Number |
bnum | Read STB Serial Number |
osdon | Set Satellite OSD On |
osdoff | Set Satellite OSD Off |
on. | Turn STB On |
off | Turn STB Off (Standby) |
stbrst | Reset Satellite STB |
atune | Read Auto Tune Parameters |
atset | Set Auto Tune Parameters |
ret | Return to Card Menu |
[Satellite (#)] Command >
where:
#is the chassis card/slot number you selected for configuration purposes.
44 |
