Configuration Options via Command Line (Cont.)
Transcoder Menu Commands
The following subsections describe how to access and use the Transcoder Menu commands.
Note: Refer to the Installation & Setup Guide for the applicable transcoder cards for further information on transcoder configuration options.
Access the Transcoder Menu
1.Access the HCS6300 Main Menu as described on page 31.
2.At the [Main] Command > prompt, type card and press Enter.
3.At the Enter card number
The system identifies the card type and then displays a command prompt for the card menu, for example:
Card #1 is: HCS7710 [HCS7710 (1)] Command >
4.At the Command > prompt, either:
•Press Enter to display the card menu (see example below).
•Type the desired command and press Enter.
Note: You can always press Enter at the Command > prompt to display the Transcoder Menu.
Example: Transcoder Menu
HCS7710 Menu
hwid | Read Hardware ID |
ver | Read Software Versions |
caget | Read Content Advisory Messages Setting * |
caset | Enable/Disable Content Advisory Messages * |
bits | Read MUX Bitrates |
pi | Install PI Key |
pr | Reload PI Key |
cksum | Read PI Key Checksum |
stb | Satellite Receiver Menu |
upd | Update Firmware |
irst | Internal Reset |
ret | Return to Main Menu |
[HCS7710 (1)] Command >
*These commands are applicable to HCS7700 and HCS7710 cards only. Refer to the LG Service Bulletin on Content Advisory configuration options for further information.
40 |
