INSTALLATION 15
Assembling the Left Refrigerator Door
Install the left refrigerator door after the right door is installed.
1Lower the door onto the middle hinge pin.
(2)(1)
(3)
(5)
(4)
(6)
(7)
(8)
2Fit the top hinge (7) over the hinge lever latch (8) and into place.
3Rotate the lever (6) clockwise to secure the hinge.
4Install the grounding screws (5) and connect the two wire harnesses (4).
5Push the water tube (3) located at the top of the left door into the hole beside the left hinge on the top of the cabi- net until it exits through the back.
6Insert the water supply tube (3) into the connector until you see only one scale mark. Fully insert the tub cover (15 mm).
7Hook the tabs on the left side of the hinge cover (1) under the edge of the top hinge (7) and position the cover in place.
8Insert and tighten the cover screw (1).
9Insert the water supply tube at least 5/8 in.
(15 mm) into the connector.
10Hook the tab on the door switch side of the cover under the edge of the wire opening in the cabinet top.
11Position the cover into place. Insert and tighten the cover screw.
NOTE
Collet
Tube 
Insert Line 
Clip
1)Gently press the Collet and insert the tube until only one line shows on the tube.
(Correct)
(Incorrect)
2)Pull the tube to make sure that the tube is tightly fastened and then insert the clip.
ENGLISH
