LG Electronics LGENBOX-01, LGxxxA1C-B3 AC output three phase 208VAC merge type

Connect hot conductors and neutral conductor in a general AC cable from the AC junction box to the designated terminal in the distribution panel.

Then, connect conductors in transition cables to the AC junction box as shown above.

AC output three phase 208VAC - merge type

To form balanced three phases, it is recommended to use 3-array and equal to the number of AC modules in each array . Below is one example for AC output cables connection of three phase 208VAC.

Meter

X6

X6

0 0 0 0 0

3-pole		3-pole
		(Determined
20A		according to the
		total current)
		G
	N L1L2L3

AC junction box Distribution panel

X6

An array of AC modules

		Transition Cable (Array ÷ AC Junction Box)
Conductor	Color	Description
L1	Black	Line to neutral voltage 120VAC.
L2	Red	Line to neutral voltage 120VAC.
Neutral	White	Common conductor used in the AC module for voltage measurements.
		External Equipment Grounding Conductor (Array ÷ AC Junction Box)
Ground	Green	Conductor to connect normally non–current carrying metal parts of equipment together.
		General Cable (AC Junction Box ÷ Distribution Panel)
L1	Black	Line to neutral voltage 120VAC.
L2	Red	Line to neutral voltage 120VAC.
L3	Blue	Line to neutral voltage 120VAC.
L1-L2	-	Line to line voltage 208VAC.
L2-L3	-	Line to line voltage 208VAC.
L3-L1	-	Line to line voltage 208VAC.
Neutral	White	Neutral wire.
Ground	Green	Conductor to connect normally non–current carrying metal parts of equipment together.

Step 1. Connect the equipment grounding conductor from the AC junction box to the terminal for grounding in the distribution panel.

Step 2. 1

2

Step 3. Check the cables to verify they have not been pulled too tight or are hanging too loose. If necessary, fixate them using the cable fixing holes on PV module frame with fixing holders, such as cable ties, so that the cables do not touch the ground.

20