LG Electronics LS-Q096ABG Checking the drainage, Form the piping, To check the drainage

Models: LS-Q096AEL LS-Q076ABL LS-Q096ADL LS-Q096BBG LS-Q096ADG LS-Q096ABM LS-Q076ABG LS-Q096ABL LS-Q096ACG LS-Q096ABG LS-Q076BBG LS-Q076BEL LS-Q096BEL

1 82
Download 82 pages 22.67 Kb
Page 32
Image 32

4. Checking the Drainage and Forming the Pipings

1) Checking the drainage

1.To remove the front panel from the indoor unit.

Set the air direction louvers up-and-down to the posi- tion(horizontally) by hand.

Remove the securing screws that retain the front pan- el. Pull the lower left and right sides of the grille toward you and lift it off.

Pull the right and the left side.

2.To check the drainage.

Pour a glass of water on the evaporator.

Ensure the water flows through the drain hose of the indoor unit without any leakage and goes out the drain exit.

2) Form the piping

1.Form the piping by wrapping the connecting por- tion of the indoor unit with insulation material and secure it with two kinds of vinyl tapes.

If you want to connect an additional drain hose, the end of the drain outlet should be routed above the ground. Secure the drain hose appropriately.

2.In cases where the outdoor unit is installed below the indoor unit perform the following.

Tape the piping, drain hose and connecting cable from down to up.

Secure the tapped piping along the exterior wall using saddle or equivalent.

Seal small openings around pipings with a gum type sealer.

Taping Taping

Drain

Drain hose

hose

 

Pipings

Pipings

Connecting

Connecting

cable

cable

LS-Q096AAL

LS-Q096ABL

3.Drain piping

The drain hose should point downward for easy drain flow.

Downward slope

• Do not make drain piping.

 

Do not raise

 

Accumulated

 

 

 

 

 

drain water

 

 

 

 

 

 

 

Tip of drain hose

 

 

 

 

Air

 

Less than

 

 

 

 

 

dipped in water

 

 

 

 

 

50mm gap

 

 

 

 

 

 

Water

 

Water

Waving

Water

 

 

leakage

 

leakage

leakage

Ditch

 

 

 

 

 

 

 

 

 

 

Trap is required to prevent water from entering into electrical parts.

3.In cases where the Outdoor unit is installed above the Indoor unit perform the following.

Tape the piping and connecting cable from down to up.

Secure the taped piping along the exterior wall. Form a trap to prevent water entering the room.

Fix the piping onto the wall by saddle or equivalent.

Seal a small opening around the pipings with gum type sealer.

Trap

Trap

-32-

Page 32
Image 32
LG Electronics LS-Q096ABG Checking the drainage, Form the piping, To remove the front panel from the indoor unit