3) Preparing work for Installation
1. Open panel front
■First,Pull the grille bottom, then remove screws(2 pieces), and close grille bottom again.
■The moment of lifting the both lower parts of panel front, you can hear sound this panel came out, In this time panel front is separated
■After pull down this panel a bit, and separate con- necting wire with product.
2. Cover pipe and cover side remove
■Remove two screws(for fixing cover pipe)
■Pull up the cover side of desired connecting direc- tion, then cover side is separated.
■In case connecting direction is left or right, path through the hole of cover side.
CAUTION
After removing the pipe hole, cut the burr for safety.
Pipe hole
Side cover
When connecting pipe path through rear wall, don’t remove the hole.
3. Drain hose junction
■ Remove the rubber stopple of desired drain direc- tion.
■ As the following picture, Insert drain hose in the handle of drain pan, and join drain hose and con- necting hose.
Panel Front
Connector
Adhesive | Only one | |
desiring direction | ||
| ||
Connecting |
| |
part |
| |
Drain | rubber cap | |
hose |
