Troubleshooting
Troubleshooting62
Troubleshooting
5
Troubleshooting

General

Symptom Cause & Solution
The Power does not turned on.
yPlug the power cord into the wall outlet securely.
The unit does not start
playback.
yInsert a playable disc. (Check the disc type, color system, and regional
code.)
yPlace the disc with the playback side down.
yPlace the disc on the disc tray correctly inside the guide.
yClean the disc.
yCancel the Rating function or change the rating level.
The angle cannot be changed.
yMulti-angles are not recorded on the DVD Video being played.
yThe angle cannot be changed for the titles recorded on this unit.
Cannot play movie, photo or
audio les.
yThe les are not recorded in a format that the unit can play.
yThe unit does not support the codec of the movie le.
The channel is not found or
stored.
yCheck your antenna connection.
The remote control does not
work properly.
yThe remote control is not pointed at the remote sensor of the unit.
yThe remote control is too far from the unit.
yThere is an obstacle in the path between the remote control and the
unit.
yThe batteries in the remote control are exhausted.
yThe remote’s manufacturer code returned to the default setting when
you replaced the batteries. Reset the code (page 65).

Resetting the unit

Symptom Cause & Solution
If you observe any of the
following symptoms.
yThe unit is plugged in, but the power will not turn on or o.
yThe front panel display is not working.
yThe unit is not operating normally.
You can reset the unit as
follows.
yPress and hold the POWER (1) button for at least ve seconds. This
will force the unit to power o then turn the unit back on.
yUnplug the power cord, wait at least ve seconds, and then plug it in
again.