Operation
5.5.3 Load a Configuration File from Disk
A previously saved configuration
This feature allows for quick setup based on another unit’s configuration or replacing a configuration file in an existing installation.
To upload the configuration file:
• Click on the Load from File button at the bottom of the Configuration window.
• In the Open window, navigate to the con- figuration file, then click Open.
After a short delay, a confirmation message appears. The Liebert LDM is now updated with all breaker and subfeed data from the configuration file that was just loaded.
5.5.4 Install Configuration Changes in the Unit | Load from File |
|
Whenever configuration changes are made using the Configuration program, the changes must be installed in the Liebert LDM using this step.
To install changes in the unit:
• Click on the Install to Unit button at the bottom |
|
of the Configuration window. | Install to Unit |
• During the upload, the circuit board will reboot. |
Once the rebooting process is complete, the configuration is now active.
NOTE
Always perform this step after making changes to the configuration. Configuration changes are not stored in the Liebert LDM until the Install to Unit button is clicked.
5.5.5Save the Configuration File to Disk
Saving the configuration file creates a copy of the current configuration, ensuring a backup is available in the event of file corruption or some other problem.
•Click on the Save to File button at the bottom of the Configuration window.
•In the Save As window:
•Specify the location where you want to save the file in the Save In box.
•Enter a unique name in the File Name box.
•Click Save.
Save to File
23
